Assembling the car camera mount is simple. First we use two 14mm wrenches to tie the 3/8"-16 bolt and nut to the metal plate. Then we arrange the two larger ...

Feb 20, 2005 · You can mount your camera inside or outside your car on the window or other smooth surfaces. It is portable too. It is pretty sturdy because it ...

Attach the camera to the bolt. Tighten the camera onto the mount with the wing nut and washer set. Now you are ready to go shoot some great bike photos and ...

Dec 7, 2007 · I built this custom adapter seen below to change tapes while maintaining tripod mount. It lifts the camera 7/8 of an inch above the tripod mount ...

Most 35mm point-n-shoot cameras today can rewound the film at mid-point. Thus, allowing different type of films to be loaded without finishing up the complete ...

Today, I came across an article on building your own "Tilt-Shift PC Lens". It is really quite an interesting article on using a rubber plunger in between ...

To clean such a smudge off can be an extremely tiring exercise. Since you can't get your whole finger through the lens opening, you can't really put the lens ...

Aug 2, 2008 · I was wondering if anyone who has purchased the new SW 1030 camera (or similar) has thought of simply cutting off the extra tab on the micro-sd ...

After removing the case cover, you can see that the sensor board and the lens takes up very little room in the case. There are a lot of empty space. Maybe it's ...