I have a few ideas on what to do with this battery pack. I could 1) rebuild it with new battery cells; or 2) turn it into a dummy battery interface so I can use ...

In order to do so, we need to understand the pin-out for all of the connectors and contacts. The picture above is the connector at one end of the DR-400 cable.

If you are wiring the 9-volt snap connector to an actual battery cell, then the black wire goes to the + contact, while the red wire goes to the - contact. I'll ...

So I attached a 9-volt battery to the BP-511 battery pack and plugged it into the Canon BG-ED3 Battery Grip (see photo below) and turned on the camera. Quite ...

Pin-out information for the Canon RS60-E3 wired remote control.

The battery pack has four electrical female pins. If you look at the bottom of the battery with the pins toward the top, you'll see that the left-most pin is ...

Oct 8, 2007 · The camera registers a voltage between the + power terminal and the dummy terminal - this allows the camera to determine if the power source is ...

Information on extending the Canon RS60-E3 wired remote control.

The Canon BG-E1 Vertical Battery Grip is an accessory for the Canon EOS Digital Rebel SLR camera. It serves two purposes: 1) it allows two batteries to be ...

I am trying to remote control my Canon EOS Elan 7e with a remote control software on Sony Clie PDA. ... Canon remote, Nevo can learn the signal. ... told you it was ...